Star-delta starting, also called wye-delta, is a classic way to reduce the violent inrush of starting a three-phase motor directly across the line. It starts the motor with its windings connected in star, then switches them to delta once the motor is up to speed, cutting the starting current and torque to roughly a third of the direct-on-line values.
A motor built for star-delta starting has both ends of all three windings brought out to the terminal box. On starting, a contactor connects the windings in star (wye), which puts a lower voltage across each winding. That reduces the starting current the motor draws from the line and the torque it produces to about one third of what a direct-on-line start would give. Once the motor nears full speed, the control switches the windings to delta for normal running at full voltage.
The catch is torque. Because star starting gives only about a third of the torque, star-delta only works on loads that can accelerate under light torque, such as unloaded pumps, fans and machines that are started without load. There is also a transition: at the moment of switching from star to delta the motor is briefly disconnected, and it can draw a current and torque spike as it reconnects, which stresses the driveline. Closed-transition schemes reduce this but add cost.
Star-delta is a cheap, robust way to tame inrush on a fixed-speed motor that starts against a light load. Where the load needs high starting torque, or where you want a controlled ramp and no transition spike, a soft starter or VFD is the better answer. Where you need speed control or energy savings, only a VFD will do.
Every start heats the windings and shocks the driveline, and repeated hard starts age a motor faster. The inrush exists because a stopped motor has no back EMF to limit current, and a start that stalls or single-phases can burn a motor in minutes, as covered in single phasing.
A monitoring platform that trends starting current and motor temperature spots a motor that is starting harder than it should, an early sign of a stiff load, a failing contactor or a winding problem. Fabrico reads that from the line and routes the work. Book a Fabrico demo to see it.
To roughly one third of the direct-on-line value, along with a matching reduction of starting torque to about a third.
When the load needs high starting torque, because star starting provides only about a third of full torque. Loaded conveyors, crushers and compressors usually need a soft starter or VFD instead.
In an open-transition scheme the motor is briefly disconnected when switching from star to delta, and it can draw a current and torque spike on reconnection. Closed-transition starters reduce this.
It is cheaper but cruder. A soft starter gives a smooth, adjustable ramp with no transition spike, and a VFD adds speed control, so both are preferred where the extra cost is justified.
Zakažite sastanak KSNUMKS-to-KSNUMKS sa našim stručnjacima ili se direktno upišite u naš besplatni plan.
Nije potrebna kreditna kartica!
Login
Blog