Key Takeaways: Stroke-count OEE is the only accurate performance metric for stamping presses. Die wear is the #1 driver of OEE quality losses. Fabrico connects press stroke counters to automated die maintenance triggers, eliminating the manual tracking that causes both missed PMs and catastrophic die failures.
See our roundup of maintenance software built for stamping and die operations.
OEE software for stamping presses fails when it only measures machine on/off state.
In stamping, press speed in strokes per minute is your performance metric. A press rated at 120 SPM running at 95 SPM has a performance rate of 79%, and that loss is completely invisible in systems that only count output parts.
Standard OEE captures major stoppages. Stamping loses most of its efficiency in the gaps no sensor catches.
The top hidden losses in stamping operations:
Fabrico captures all three. Its OEE engine reads directly from press controllers and feed system sensors, giving you the granular loss breakdown that generic monitoring platforms miss.
Die maintenance scheduling in stamping is fundamentally different from calendar-based PM.
Die wear accumulates based on press cycles, not calendar time. A die running on a high-speed 200-SPM transfer press hits its maintenance interval in hours. The same die on a 30-SPM single-station press takes days.
Calendar-based PM gets this wrong in both directions, you'll over-maintain slow lines and under-maintain fast ones.
Fabrico's CMMS connects directly to the OEE stroke counter. When a die reaches its maintenance interval in cycles, the system generates a work order automatically, no manual tracking, no guesswork.
The impact is measurable. Operations using Fabrico's stroke-count PM triggers report:
Die repair scrap tracking closes the loop: Fabrico connects CMMS die repair work orders to the OEE quality loss that triggered them, identifying the failure modes that create the most scrap. That data directly informs where to invest in die improvement.
Most OEE platforms were built for assembly lines. Stamping operations need a different set of capabilities.
Before evaluating any platform, confirm it passes these non-negotiables:
Fabrico is the only platform that combines native OEE stroke-count monitoring with an integrated CMMS that triggers die maintenance automatically.
For automotive stamping suppliers operating under IATF 16949, Fabrico provides the TPM documentation evidence, connecting OEE measurement to die maintenance records, in the auditable format that IATF auditors require. No manual cross-referencing. No evidence gaps.
The result: fewer die failures, lower scrap rates, and a maintenance program that scales with actual press utilization rather than the calendar.
Login
Blog